BLOG – Page 3 – Subha IT Solution

how to factory reset ASR 1001-X

1st > erase startup-config after that > reload Note : Do not save the running configuration when prompted.

How do I change the Huawei console port password?

Change the console port password. In this example, you set the authentication mode to password authentication and the password to subhais@123....

Click Here

What is the command for the interface range? at Huwaie Switch

<3328> system-view interface range gigabitethernet 0/0/1 to gigabitethernet 0/0/2

Click Here

How To Force Your Cisco Switch To Use 3rd Party SFPs

Despite the error displayed, which leaves no hope for a solution, keep smiling, as you're about to be given one....

Click Here

MikroTik RouterOS v7 Route Filters

MikroTik RouterOS v7 Commonly Used FiltersNotes about using the filers Starting in ROSv7, the filters are in a “normally closed”...

Click Here

Mikrotik showing only 1 single line of log messages !

Question: I am not able to determine why my Mikrotik box shows only a single line of log information.I checked...

Click Here

GRE Configuration Between Mikrotik And Cisco Router

CiscoRouter Configuration: R1>enable R1#conf t R1 (config)# hostname CiscoRouter CiscoRouter (config)# interface FastEthernet0/0 CiscoRouter (config-if)# ip address 104.10.1.2 255.255.255.252 CiscoRouter...

Click Here

How to block specific IP address at Mikrotik?

Step-by-step guide Follow these steps to add filter rule using Winbox: Go to IP>Firewall; Select tab "Filter rules"; Click on...

Click Here

BDCOM Epon OLT All Show Command

show epon active-onu – All Active ONU information show epon active-onu interface epoN 0/1 – Specific active onu information show...

Click Here

Huwaei GPON OLT LACP (Link Aggregation) Command

link-aggregation 0/2 (MCU Card Number) 0 ( Interface Number) egress-ingress port vlan (As per your Requierment ) 0/2 0 link-aggregation add-member...

Click Here

How To Reset Switch Port – Cisco switch?

Command : 1st go-to global configuration mode then " default >interface name<

Click Here

PL2303HXA Phased out since 2012. Please contact your supplier (SOLVED)

Some Cheap Chinese FTDI cables use a fake chipset from Prolific. Prolific has prohibited the use of these cables. Windows...

Click Here

VSOL OLT LACP With Mikrotik (Bonding)

Mikrotik End /interface bonding add name=bonding slaves=ether11,ether12 At Vsol End LACP Configuration: epon-olt(config)# channel-group 1 mode static epon-olt(config)# channel-group 1...

Click Here

VLAN BASED BANDWIDTH CONTROL IN BDCOM SWITCH

step – ১: প্রথমে আমাদের একটা policy-map তৌরী করতে হবে। এজন্য আমাদের config mode এ যেতে হবে। তারপর কম্যান্ড লিখতে...

Click Here

BDCOM Switch Reset Configuration

For the test, I perform a reset on the BDCOM P3310C-2AC, and similarly, it can be reset on other BDCOM...

Click Here

Juniper VS MikroTik – BGP commands

Juniper CommandMikroTik Commandshow bgp summaryrouting bgp peer print briefshow bgp neighborrouting bgp peer print statusshow route advertising-protocol bgp 172.31.254.2routing bgp...

Click Here